ME OLVIDE DELA FOTO

Glad it works.

You can also use 100 ohm resistors instead of 220 ohms for the displays, as they only light up 1/10 of the time.

To see the difference, you should reprogram the original display scan generator with C11.

Remember when I wrote that you should have used CC displays?

You're making the same mistake as back then: the output of {7 segment display A} is inverted compared to when you use {7 segment display C}.

Illuminating segment 'a' is equivalent to 1111110 for CA displays and 00000001 for CC displays.

If you use the AND 1 instruction, that's correct for CC displays, but you should invert '1' for CA displays.

You can also indicate that you're using CC displays and invert the outputs as I did in your example, while still using CA displays.

I also removed 4 times {MOV display 0xFF}

I have not tested it in real, that upto you.

Good luck