|
LDmicro Forum - PLC Cycle Time 0 |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
PLC Cycle Time 0 (by Ihor Nehrutsa)
(no subject) (by MGP)
This is good for counting pulses and I wonder how fast we can go, I can wait for doing a test ;-)
A week ago I made a program with a cycletime of 0.2mS and each timer(TON,TOF....) was counting double, 100mS became 200mS, 1s was 2sec. The reason was that the program wat too big for a cycletime of 0.2mS and LDmicro skip over 1 cycletime without warning.
(no subject) (by Ihor Nehrutsa)
Can you publish a LD with 0.2mS cycletime? I want to test TON...
(no subject) (by MGP)
It's the same program I sent you a week ago with the % error.
Change the cycletime in 0.2mS and if you program it in a 16F628a all timers double their values. But for me it's no problem, do not waste too much time, I know that I have to pay attention if I work with cycletimes <1mS If you deleted it I will sent it you again.
(no subject) (by Ihor Nehrutsa)
When you set the PLC cycle time, you
can look admissible values at this line 'Available PLC Cycle Time: min= ### us, max= ### ms' I will add additional check.
(no subject) (by MGP)
Thanks, I forgot this line in the menu setup, too busy with programming ;-)
(no subject) (by Alex)
is it like when you want to make a turn on a led program (hello world) using one button then you donīt need to add time cycle?
Post a reply to this comment:
|
|
|