How to make MPLAB auto program (by David R)
Hi,
Does any one know how to set MPLAB IDE to auto program when
Ldmicro changes the .hex file.
I am using pickit3.
Kind Regards
David.
(no subject) (by Jonathan Westhues)
I'm not sure about the PICkit 3. The PICkit 2 came with separate (not a part of MPLAB) software that would auto-program whenever the hex file changed.
(no subject) (by David R)
Hi Jonathan,
Ok I had A read and pickit3 only runs inside MPLAB_IDE.
I will see if I can use A hot key or commandline.
Could Ldmicro run A user preset commandline with A hotKey
This way there is no dependency on any type of programmer
as there is only "run command line" this could be "F6"
Regards
David.