Arduino UNO (by Deck Medina)
Hello,
I've created a simple START-STOP SWITCH in LDmicro and simulate it and its working fine. But when I upload it to Arduino Uno, the operation is erratic. Any suggestion on how to correct this?
(no subject) (by paulino)
Como copilaste en .HEX o Para arduino,
si usas placa arduino tienes que copilar y guardar en la misma carpeta de arduino.
el .HEx lo hace para cargarlo al microprocesador sin placa de arduino para colocar el Chic sobre otro circuito que hagas.
As you copied into .HEX or For arduino,
if you use arduino board you have to compile and save in the same arduino folder.
the .HEx makes it to load it to the microprocessor without arduino board to put the Chic over another circuit you make.
(no subject) (by Elmit)
Numai PC6 si PC7 sunt numai intrari analogice . Cu celelalte trebuie sa functioneze .Atentie la tipul de microcontroler posibil ca placa sa fie cu 168 in loc de 328 .
Puteti folosi pentru a scrie fisierui .hex programul Xloader
.e mai simplu. Eu am folosit intrarile analogice fara probleme ca intrari digitale.
Arduino UNO (by Deck Medina)
Hi Toni,
I've tried to assign my inputs on pin2 & pin3 on Arduino Uno & still erratic. Any more suggestions?
(no subject) (by paulino)
Hello friend I am attaching a folder that I must place for arduino
Hola amigo te adjunto carpeta que debes colocarla para alduino.
(no subject) (by Deck Medina)
Hi Paulino,
Your Sample_1.rar file does not contain the "ladder.h" file
(no subject) (by paulino)
I made you a test you can put yourself in the folder.
te hice una prueba puedes colocarlo tu mismo en la carpeta.