|
LDmicro Forum - LDmicro program for automatic transfer switch (ATS) |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
LDmicro program for automatic transfer switch (ATS) (by Jose Espinoza)
Good afternoon, I made a ladder logic with the Ldmicro program for one ats.
After done I have compiled it for arduino sketch (I have an arduino nano atmega 328P V3.0). When compiling the program, the file is generated in the arduni IDE and generates the errors that are shown. I am attaching the detaller in power point file. I would like someone to tell me what is the solution to eliminate errors. Thanks in advance.
LDmicro program for automatic transfer switch (ATS) (by Jose Espinoza)
LDmicro program for automatic transfer switch (ATS) (by Jose Espinoza)
Good afternoon, I made a ladder logic with the Ldmicro program for one ats. After done I have compiled it for arduino sketch (I have an arduino nano atmega 328P V3.0). When compiling the program, the file is generated in the arduni IDE and generates the errors that are shown. I am attaching the detaller in power point file. I would like someone to tell me what is the solution to eliminate errors. Thanks in advance.
(no subject) (by Ihor Nehrutsa)
0) (Optional) Use menu File->Save LDmicro0.2 file format.
LDmicro0.2 file format saves compiler type and when once use menu "Compile Sketch for Arduino", then you will compile for Arduino by menu "Compile" F5 key. 1) Delete file "ladder.h_" in the same directory with your PRUEBAV0.ld 2) Use http://cq.cx/ladder-forum.pl?a...;parent=8232&tt=1551133711
Post a reply to this comment:
|
|
|