|
LDmicro Forum - Siren |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
Siren (by Marius)
Howdy
A little help? They make an automation for a silo that is powered by 4 conveyor belts. S1 is a maximum level sensor for the material. offbanda1-offbanda4 are sensors that confirm the conveyor belt is in operation (the silo operator can choose which conveyor belts will feed the silo, may be all or just one). When the material reaches s1 it gives the command and stops the conveyor belts, which are in operation. What I can not do. I want that when the material falls below this one after a while it will command a siren. The siren is set to notify the operator that the conveyor belts must be turned on. Starting conveyor belts is done manually for safety reasons. Thank you
(no subject) (by MGP)
Can you simplify your program? so without LEDs and uart and add some comment.
Siren (by Marius)
Uart communication is to connect the system to your pc.
The LED is to confirm that it started running the micro program. I forgot to say that the siren must stop when the operator starts the conveyor belt. Thank you
Post a reply to this comment:
|
|
|