|
LDmicro Forum - interface UART 4D display system |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
interface UART 4D display system (by segar )
Hi, all
I have recently developing project in the HMI with 4d display system with LDmicro interface via UART. But i can't interface with this 4D module the website below and i using. Model: gen4-ULCD-32DT Website:http://www.4dsystems.com.au My email: [email protected] Please i need help , if any one have done this please share some information its will very help full for every one. Thank You
(no subject) (by MGP)
I think ldmicro is not suitable for communicating with such a display.
Was previously planning to buy a Nextion LCD, but I did not do that for the same reason. I think an arduino is a better device. But you never know ;)
interface UART 4D display system (by segar )
Hi,MGP
I know that the Arduino Board but that is not for industrial application and also its not suite for heavy industrial application i have use this arduino mega and UNO its always give problem after installation in industrial. The problem is some error and system offline the arduino need to reset always. my customer always complaint about arduino board after i completed. So from there i not use arduino any more i have no confidence.but in LDMicro i made and install to heavy industrial its best and very robust use no any problem until now all most 3-years my customer use. so any how thanks for your reply. Thank you
Post a reply to this comment:
|
|
|