timer adjustment (by Marc-Olivier Gemme)
I don't know how to make this with this ladder software:
Variable timer to close:
2 input button, one to change Minutes and the second to change seconds. Each pulse will increase min or sec up to 5 minutes than will return to 0.
EX: if I set the timer 2 pulse on the minute button, the timer to close will be set as 2 minutes.
after 2 minutes I need a pulse to turn on the motor.
Thank you very much for your precious help
(no subject) (by Ihor Nehrutsa)
Is there two task?
1)Set setpoint value. 2 input button, one to change Minutes and the second to change seconds.
2)The second problem is not clear. Tell please more about.
(no subject) (by Marc-Olivier Gemme)
Thank you so much
There are the missing things
Exemple: If I set the time at 1min 0sec. I need a dry contact output of 1 second after the 1min 0sec timer.
I also need a reset input to reset the time to 0min 0sec.
(no subject) (by Ihor Nehrutsa)
Every Cm:Cs we get a blink(flash) with duration of 1s.
Note: If Cm:Cs <= 0m:1s, then Ygate is always ON.