sir please post the schematic pic877 for mill_controller.ld.
or
the block diagram.
thanks
Fri Nov 28 2014, 12:06:41
(no subject)(by Jean-Pierre)
hello
What is the "mill_controller"
Sun Nov 30 2014, 05:55:19
(no subject)(by David R)
hi ikram i think i know what you are talking about did you still want the info on the cnc mill controller?
Kind Regards
David
Sat Dec 27 2014, 05:14:13
(no subject)(by ikram)
sir please point out these output.
Y_unlatch_x
Y_unlatch_y
Y_unlatch_z
where these connet.
thanks
Fri May 1 2015, 10:58:10
(no subject)(by David R)
HI the micro-controller is interfaced with a SR-latch cmos chip
because the pulse from the cnc controller is to short for the
micro-controller to see.
So the pulse sets the SR-latch and the micro-controller resets the SR-latch once the signal is registered.
Please note this controller is no longer in use as i brought stepper drivers off aliexpress and only use the micro-controller to do stuff like the tool change etc.
Kind Regards
David
Thu May 21 2015, 21:09:13
(no subject)(by ikram)
sir please post a simple schematic for this drive. thanks