(you are viewing a thread; or go back to
list of threads)
atmega128a au is that work properly ? (by MFQ)
this ic number i will purchese
please inform me this ic i purchase atmega128a au ?
atmega128 au on LDMIRCO (by jimson james)
yes is used that already,it work properly.
i used forty of its pins all the same time....i made avr to avr comcunication,i did it by using atmega8a as transmiter and atmega128 au as receiver.
THANKS A LOT JIMSON JAMES (by MFQ)
DEAR
THANKS A LOT TO INFORM ME ATMEGA128 AU
two thumbs up (by Jayson Agustin)
MFQ ,,,jimson james is my co employee before,,,it is already prove... i testify....anyway i was learn a lot with your micro PLC Mr.jimson...now i can make a simple program and still learning with the machine u made.
atmega128 (by Magno Medeiros (Brasil))
Hello, MFQ.
If I understand correctly, you're wondering if the Atmega128 works well, correct?
Yes, it works! Have ridden some PLCs using all pins this microcontroller and no problems. One should note the configuration of FUSES if I'm wrong does not work. Below is an example of what I rode.
atmega128 (by Magno Medeiros (Brasil))
another example.
nice design (by Jayson Agustin)
can you share the circuit of your example sir
atmega128 (by Magno Medeiros (Brasil))
yes, below diagram. any questions you can ask.
atmega128 (by Magno Medeiros (Brasil))
Hello, I posted this wiring diagram is actually this model PLC that follows, note that adding 25 entries plus 27 outputs and the RUN LED, I used all of the ATmega128 pins.
atmega128 (by Magno Medeiros (Brasil))
Continued .....................................................
atmega128 (by Magno Medeiros (Brasil))
Continued .......................................
Post a reply to this comment:
|