|
LDmicro Forum - serial comm simulate with proteus 7.6 |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
serial comm simulate with proteus 7.6 (by Adli)
dear sir,
i am a beginner in ld micro.. there is a problem with my serial comm.. i try run this program in Proteus 7.6.. for my 1st program there is no any problem.. but when i add a 'Contacts' to turn ON the 'Coil' in the previous program manually, the simulate cant run.. can anyone explain about it? cycle time : 10ms baud rate : 9600 *sorry for my bad english..
(no subject) (by MGP)
Adli,You may not use 2 times the same coilname, except set/reset.
Try this program.
problem with PIC's pin (by Adli)
TQ MGP..
now i try to send a string to the PIC to turn ON the output.. for my 1st try,i use the pin33 (RB0) for the output and its works but when i try to change the output to the pin19 (RD0) its did not works could you please explain about it..
(no subject) (by MGP)
I think you made a programming error, change ( CTC C1 ) = 5
It has nothing to do with the output pins.
(no subject) (by Adli)
I dont think my programming is wrong,
I use PIC16F877 and i have tried all port number pins for the output and its all working. But when i use any number pin of PORT D, there is no feedback.
Post a reply to this comment:
|
|
|