|
LDmicro Forum - Ladder logic on ISPSoft |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
Ladder logic on ISPSoft (by Luiz)
Hello there, I'm trying to use the ISPSoft for the first time ( for delta PLC's).
But I believe it's not going the expected way. In the print below, the m1002 memory is on when we switch from STOP to RUN state. And when I press X0, it activates Y1 and reset Y0, ok. But when I release it. Y1 goes to 0 and Y0 returns to 1 position, instead of activating Y2
(no subject) (by Paulino Calubert)
Hola conozco bien la programación de delta pero este programa de LDMicro no es compatible, pero si lo escribes en LDMicro te funcionara igual.
EL PROBLEMA QUE TIENES ES QUE NO PUEDES REPETIR LAS SALIDAS Y0, Y0. PARA QUE TE FUNCIONE TIENES QUE CAMBIAR LAS ( Y POR (M) QUE SON LOS RELES INTERNOS) LOS RESET LOS TIENES QUE HACER SOBRE lAS (M MRCAS INTERNAS ) ENTOCES COLOCA LAS SALIDAS (Y). Hello, I know delta programming well but this LDMicro program is not compatible, but if you write it in LDMicro it will work just the same. THE PROBLEM YOU HAVE IS THAT YOU CANNOT REPEAT THE OUTPUTS Y0, Y0. FOR IT TO WORK YOU HAVE TO CHANGE THE ( AND FOR (M) WHICH ARE THE INTERNAL RELAYS) YOU HAVE TO RESET THEM ON THE (M INTERNAL MARKS) THEN PLACE THE OUTPUTS (Y). VERY IMPORTANT NOTE: This happens in all types of PLC ladder programming as in LDMicro and I think in C++
Post a reply to this comment:
|
|
|