|
LDmicro Forum - About Stepper / Pulser contacts |
|||
|
|
|
(you are viewing a thread; or go back to list of threads)
About Stepper / Pulser contacts (by José)
Does any one know anything about Pulser / Stepper contacts
si that I can translate their transfer functions in C ?
(no subject) (by Caluber paulino)
Copy it in (C) that LDMicro does and you will see it in (C). Look in the manual there is an explanation of how to do it. http://en.wikipedia.org/wiki/Bitwise_operation > DESPLAZAMIENTO ARITMETICO: SHL, SHR. https://en.wikipedia.org/wiki/Arithmetic_shift [TCY 500 ms]- > DESPLAZAMIENTO LOGICO A LA DERECHA SR0. https://en.wikipedia.org/wiki/Logical_shift 500 ms]- El cambio lógico a la izquierda es equivalente a SHL cambio aritmético a la izquierda. > DESPLAZAMIENTO CIRCULAR: ROL, ROR. https://en.wikipedia.org/wiki/Circular_shift inea. Puede agregar más niveles seleccionando inserte Rung Before / After en el menú Logic. Podrías obtener el mismo efecto colocando muchos subcircuitos complicados en paralelo en un linea, pero es más claro utilizar múltiples escalones.
(no subject) (by José)
Hi Paulino
Thanks for your answer but unfortunately there's nothing in the help about stepper / pulser... I have already had a look at the C code generated by ldmicro for those contacts but it's not clear at all ! BR José
(no subject) (by calubert paulino)
(by José) look at this I think I can give you an explanation of how to do it
(por José) mirate esto creo que te puede dar una explicación de como hacerlo https://github.com/LDmicro/LDmicro/wiki/PULSER
(no subject) (by calubert paulino)
I enclose a test of how to do the steps and I put an analogous entry, so that you vary the steps and you will measure ..
NOTE: Depending on which version = does not work, I did the example with the latest version. Te adjunto una prueba de como hacer los pasos y te puse una entrada análoga, para que varies los pasos ya mediras..
(no subject) (by José)
Thank you dear Paulino ; your link is fine !
I didn't answer before because I was off-line. I'll test a Pulser within a few days. BR José
(no subject) (by José)
Paulino:
Do you know a link explaining as well STEPPER instruction ? (For stepper motors I suppose...) José
(no subject) (by Paulino calubert)
(para José)
Es para motor paso a paso https://github.com/LDmicro/LDm...motor.-Phase-current-waveforms https://github.com/LDmicro/LDmicro/search?q=STEPPER
(no subject) (by Paulino calubert)
para José.
te hice una prueba, si ves te puse una analogica para mover el contador y si ves el contador veras que va disminuyendo hasta llegar a 0 el CstepDec
(no subject) (by José)
OK
Thanks Paulino. I know how stepper motors work, but I have to understand how it's implemented in ldmicro. I'll have a look at you examples ! José
(no subject) (by Paulino calubert)
Ok ya dirás
Post a reply to this comment:
|
|
|