Printing the ladder diagram (by Frank)
Is anyone else having issues with printing a ladder diagram ??..If i save it as a text file and then open it with ms word it doesnt appear to be formatted correctly and prints as it looks in ms word.....if i open it in wordpad it opens formatted correctly but prints unformated...any ideas ???
Thanks
Frank
(no subject) (by Frank)
Not sure what i did wrong but i just changed to landscape , (which i thought i had tried)...and sure enough it prints.. i have an old printout here of a project i did a while back and i have printed it out in portrait mode fine ?...Anyway thanks very much for your help...much appreciated .
Cheers
Frank
(no subject) (by Ziggy)
NOTE : it has been a while since i looked at this BUT i think the following applies
... look out for the width ( number of elements that can be connected in series on the ladder rung.
I think there are two options...
Select minimum number so as to allow portrait orientation of paper.
Otherwise select smaller FIXED WIDTH font to retain proper formatting.