New Pulser and Stepper instructions (by DanielH)
Please, could someone explain in detail (function, parameters, used variables) the new Pulser and Stepper instructions?
These are not explained in manual.txt nor in Github wiki.
Thanks you in advance...
(no subject) (by Ziggy)
Stepper drivers come in a couple of flavours....
STEP signal and DIRECTION signal
both are easy to understand.. the stepper driver when driven with STEP signal will cause the motor to move one (micro)step in forward or reverse direction depending on DIRECTION signal.
Some drivers have a FORWARD STEP input and a REVERSE STEP input. only one of these is stepped at any time.
I have had a look at the stepper command and I can not venture a guess on how to use it presently.
You could implement low level stepper programing by handling each phase of the stepper motor drive requirement by bit banging the phases.
(no subject) (by MGP)
Be a bit patient, if the manual says nothing about it then it is not yet in use.
In the meantime, you can enjoy creating a program that does the same, very instructive. ;-)