(you are viewing a thread; or go back to
list of threads)
16f877a configration (by ikram)
pls see the attachment and help me what are need mark and what are unmark. when hex file genarate by ld micro
thanks
ikram
(no subject) (by ikram)
thanks can we use 16F877a in ld micro . while its not listed .i creat a hex file for 877 and program it to 877A that not work . what difrents here.
(no subject) (by MGP)
Can you upload your program (LD-file) so we can see what's wrong.
I always work with a 16F876A and never had any problems and it's not so different than a 877A.
(no subject) (by magno (Brasil))
Hello Ikram,
often use the PIC16F877 without any problem, the only restriction is to not use pin 6 as output. as software programming using the ECLIPSE and MICROBRN (DIY K150 V 150807) as pictures below. if you want I can send you this software without problem.
(no subject) (by magno (Brasil))
Olá Ikram,
muitas vezes usar o PIC16F877 sem qualquer problema, a única restrição é não usar o pino 6 como saída. como programação de software usando o ECLIPSE e MICROBRN (DIY K150 V 150807), como fotos abaixo. se você quiser eu posso enviar-lhe este software sem problema.
(no subject) (by ikram)
hi magno
thanks for your reply.
i remove pin#6 from output and i also pulldown the inputs.its run now . but i use the <G540> china programer. its not read the ld microw file configration word.
now tell me
#1: i can use the RX and TX pin as other input or out put. or this is uneik for comunication.
2#: can we program the 877 or 887 in circuit with out programerby max232 if yes how.
also yes send me (DIY K150 V 150807)
thanks
(no subject) (by magno (Brasil))
Hello Ikram,
yes you can use the pin 25 and 26 (TX and RX) as input or output, I have circuit that uses 2 pins as inputs and have another that uses 2 as output. as the second question I do not answer you know, I just use a program "ICSP" or socket "ZIF". I can only send you the software via email because the file size is 24MB.
on delay timer (by ikram)
helo magno.
i need 3 output with on deay. and want to use external pot. i not know about adc. are u can send the schimatic for this . thanks
adc (by segar)
dear friends ,i am new to micro controller projects,i would like to know how to write the ADC in the lcd/seven segment display .
thanks
Post a reply to this comment:
|